Fault finder: Bird feeder visit counter

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Counts every few seconds without a bird: what should I check?

Turn the sensor knob to reduce its range or shade it from the sun.

Never counts: what should I check?

Turn the knob up and check the OUT wire goes to D2.

RTC not found message: what should I check?

Check the I2C wires and the module's coin cell.

Blank screen: what should I check?

Check the OLED wires and try address 0x3D.

Wrong time: what should I check?

Set the clock again with the RTClib example.