Fault finder: Binary flash-card quiz

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No guess shown: what should I check?

Check the wiper is on A0 and the serial monitor is at 9600 baud.

LEDs in the wrong order: what should I check?

Bit 3 is on D6 and bit 0 is on D9.

Guess jumps: what should I check?

The knob may be noisy, turn it slowly.

Same number again and again: what should I check?

Check the random seed line is present.

LED dim: what should I check?

Check 220 ohm values and the LED direction.