Fault finder: Boat bilge leak alarm

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No alarm in water: what should I check?

Print the level and lower WET_ABOVE below the wet reading.

Alarm with a dry sensor: what should I check?

The sensor board may be damp, so dry it and raise WET_ABOVE.

Always reads 0: what should I check?

Check S goes to A0 and the plus pin goes to D7.

Silent alarm: what should I check?

A passive buzzer needs tone(), so check it goes to D8 and the right way round.

The traces are turning green: what should I check?

The sensor was powered all the time, so use the D7 pulse as in the sketch.