Fault finder: Two-colour status light

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing lights: what should I check?

Check the pin order and that the common pin is on GND.

Only one colour works: what should I check?

Check each resistor and wire.

Colours are inverted: what should I check?

Set COMMON_ANODE true and wire the middle pin to 5V.

Orange looks yellow: what should I check?

Lower the green value.

Orange looks red: what should I check?

Raise the green value a little.