Fault finder: Bed position turn reminder

10 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always empty: what should I check?

Pads are not loaded enough. Use stiffer plates or raise the pad sensitivity.

Wrong position: what should I check?

Re-check which pad is which and the readings in each position.

Timer never resets: what should I check?

The change must last the confirm time.

Noisy readings: what should I check?

Seat the sensors flat and keep wires short.