Fault finder: Under-bed night light

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Strip flickers: what should I check?

Check the grounds and the gate resistor.

Never turns on: what should I check?

Raise DARK or check the PIR output pin.

Always on: what should I check?

Lower DARK or aim the PIR away from heat.

Strip glows when off: what should I check?

Check the gate pull-down resistor.