Fault finder: Battery internal resistance meter

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Resistance reads zero: what should I check?

Voltage drop is below the ADC step; average more or use an INA219.

Load stays on at power-up: what should I check?

Check the gate pull-down resistor.

Strange values: what should I check?

Enter the real VREF and the measured load resistance.

Resistor too hot: what should I check?

Shorten the pulse.