Fault finder: Bathroom exhaust fan on humidity

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Fan never starts: what should I check?

Check the relay polarity (active LOW or HIGH).

Fan runs all the time: what should I check?

Lower the baseline learning rate or raise RISE_ON.

Sensor reads strangely: what should I check?

Keep it away from the fan's airflow and heat.

Relay chatters: what should I check?

Check that RISE_OFF is less than RISE_ON.