Projects / Aurora ring lamp / Fault finder

Fault finder: Aurora ring lamp

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No light: what should I check?

Check the ring's 5V and GND and that DIN is the input side.

Wrong colours: what should I check?

Change NEO_GRB to NEO_RGB.

Flickers: what should I check?

Join all the grounds and fit the capacitor and resistor.

First LED wrong: what should I check?

Keep the 330 ohm resistor close to the ring.

Too dim or too bright: what should I check?

Change BRIGHT_MAX, but keep it low.