Fault finder: Remember settings with an EEPROM

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Display blank: what should I check?

Try address 0x3F and check the contrast screw.

Count resets on restart: what should I check?

Check the EEPROM wiring and address pins.

Wrong number after restart: what should I check?

Check the sequence and checksum code.

Chip not found: what should I check?

Run an I2C scanner, address should be 0x50.

Slow after each press: what should I check?

Normal, the code waits for the write to finish.