Projects / Ramp slope checker / Fault finder

Fault finder: Ramp slope checker

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reads nothing: what should I check?

Check the address 0x68 and the I2C wiring.

Does not zero: what should I check?

Keep it still for the first 3 seconds.

Angle seems backwards: what should I check?

Turn the sensor round so X points up the slope.

Noisy: what should I check?

Keep it still while reading and avoid vibrations.