Fault finder: 0 to 25 V DC voltmeter with LCD

5 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading a little off: what should I check?

Measure the 5V pin and set VREF. USB supplies are often 4.8 to 5.1 V.

Reading jumps around with probes open: what should I check?

Normal: an open input floats. Short the probes to see 0.

Never above 25 V, and DC only: what should I check?

More than 27 V puts over 5 V on A0. Never connect it to mains or AC.