Fault finder: Indoor air quality monitor with MQ-135

11 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Starts at Poor: what should I check?

It was started in stale air. Restart next to an open window.

Numbers drift through the day: what should I check?

Metal-oxide sensors change with temperature and humidity. This shows trends, not exact gas levels.

Need real numbers: what should I check?

For CO₂ in ppm, use the SCD40 build. For dust, use the PMS5003 build.