Fault finder: Comfort index display

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

AHT20 not found: what should I check?

Check SDA and SCL and the supply voltage of your module.

OLED not found: what should I check?

Try address 0x3D instead of 0x3C.

Temperature reads high: what should I check?

Move the sensor away from warm parts.

Display is blank: what should I check?

Check the display library size, 128 by 64.

Text is cut off: what should I check?

Reduce the text size.