Fault finder: Cattle trough fill controller
8 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Valve never opens: what should I check?
Check the 12 V supply, the gate drive and the diode direction.
Valve opens when full: what should I check?
Flip LOW_WHEN_CLOSED.
Alarm too soon: what should I check?
Increase MAX_FILL_MS for a slow supply.
ESP32 resets: what should I check?
Check the common ground and the supply.
