Projects / Digital protractor / Fault finder

Fault finder: Digital protractor

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Does not start: what should I check?

Check the sensor wires and the address 0x53.

Angle is always 0: what should I check?

Check SDA and SCL are not swapped and the library is installed.

Number jumps: what should I check?

Hold the board still, and keep wires from pulling on it.

Wrong by a few degrees: what should I check?

Use the zero button on a surface you trust.

Reads 90 flat: what should I check?

Mount the board so the X to Z plane is the one you want to measure.