Projects / Three-axis g meter / Fault finder

Fault finder: Three-axis g meter

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Readings off by a lot: what should I check?

Check that 3V3 is wired to AREF.

Always zero: what should I check?

Check the supply and the axis wires.

Z not 1 g: what should I check?

Fix COUNTS_PER_G with the flip test.

Noisy numbers: what should I check?

Keep the sensor wires short and away from the display.

Chip very hot: what should I check?

5 V on a bare chip, disconnect it at once.