Fault finder: Small DC current meter

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading is negative: what should I check?

Swap the load wires on IP+ and IP-.

Reading stuck near zero: what should I check?

Check the load really passes through the sensor terminals.

Reading drifts: what should I check?

Re-upload with the load off so the zero is measured again.

Screen blank: what should I check?

Try address 0x3F and turn the backlight contrast screw.

Values far off: what should I check?

Check the module version and set SENS to 0.100 or 0.066.