Fault finder: 555 PWM motor speed controller

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Fan does not run at all: what should I check?

Check the MOSFET pins: gate, drain, source face-up from left to right on an IRLZ44N.

Fan whines: what should I check?

PWM frequency is audible. Use 10 nF instead of 100 nF to raise it, or accept the sound.

Speed does not change: what should I check?

Check the diodes' directions: D1 and D2 face opposite ways.

555 gets hot: what should I check?

The 1 kΩ pull-up is shorted or the supply is above 16 V.