Components / Sensors / Heart rate and ECG sensor AD8232

Heart rate and ECG sensor AD8232

Single-lead ECG front end with electrode pads.

MeasuresECG (heart electrical signal)
InterfaceAnalog plus lead-off outputs
Supply voltage2 to 3.5 V
Watch out forNot a medical device; never connect while plugged into mains
SensorsReviewedMPN AD8232Used in 2 projects
AD8232
In short

What is the Heart rate and ECG sensor AD8232 and what is it used for?

Single-lead ECG front end with electrode pads. Makers use it for learning about ECG signals.

How it works

An instrumentation amplifier and filters pick up the millivolt electrical signal of the heart from skin electrodes.

Key specifications

Sensor specValue
MeasuresECG (heart electrical signal)
InterfaceAnalog plus lead-off outputs
Supply voltage2 to 3.5 V
Watch out forNot a medical device; never connect while plugged into mains

Pinout

GNDGround
3.3VSupply
OUTPUTAnalog ECG
LO− and LO+Lead-off detect
SDNShutdown

How to use it

Power the circuit from a battery only, or a laptop running on battery: never from mains. Place pads as shown by the board maker, keep still, and sample at about 250 to 500 Hz. Learning use only.

Applications

Alternatives

Buy at

Common questions

What is the Heart rate and ECG sensor AD8232 used for?

In maker projects: learning about ECG signals.

How does the Heart rate and ECG sensor AD8232 work?

An instrumentation amplifier and filters pick up the millivolt electrical signal of the heart from skin electrodes.

What voltage does the Heart rate and ECG sensor AD8232 need?

2 to 3.5 V.

How do I connect the Heart rate and ECG sensor AD8232 to an Arduino or ESP32?

Analog plus lead-off outputs. Pins: GND (Ground), 3.3V (Supply), OUTPUT (Analog ECG), LO− and LO+ (Lead-off detect), SDN (Shutdown).

What can I use instead of the Heart rate and ECG sensor AD8232?

Heart rate sensor (pulse sensor).